A Dallas commercial facility contacted 2EZ TEK needing a PRX Performance Profile Pro Ark power rack installed on an interior brick load-bearing wall. The facility was expanding its strength training area and needed the rack mounted securely, flush to the wall, so it could fold away when not in use. Getting this wrong on a brick surface means a rack that shifts, anchors that pull, or worse, a safety failure under load.
The Problem
The facility manager needed the PRX Profile Pro Ark anchored to a brick load-bearing wall, which is a different process than a standard wood stud or concrete block installation. Brick requires the right anchor hardware, correct spacing, and confirmation that the wall can handle the dynamic load of heavy barbell work. The facility also had a StairMaster, treadmill, and elliptical on the floor that needed evaluation for upcoming service and repairs.
What We Found
On arrival, the tech assessed the brick wall and confirmed it was a true load-bearing structure with solid brick construction, not a veneer. That distinction matters because veneer brick cannot safely anchor a rack rated for the loads the Profile Pro Ark is designed to handle. The wall was suitable, but the installation required sleeve anchors sized and torqued correctly for masonry, not the standard lag bolts used in wood-framed walls. Pilot holes had to be drilled at precise depth to seat the anchors without cracking the mortar joints.
How We Fixed It
The tech drilled into the brick using a hammer drill with a masonry bit, set the correct diameter sleeve anchors at the manufacturer-specified mounting points, and torqued each anchor to spec before mounting the rack frame. The PRX Profile Pro Ark was then assembled, leveled, and tested through its full fold-in and fold-out range of motion to confirm smooth operation and zero wall movement under simulated load. Before leaving, the tech also walked the cardio floor and documented the condition of the StairMaster, treadmill, and elliptical to prepare accurate service quotes for each unit.
The Outcome
The PRX Profile Pro Ark was installed solid, level, and fully operational on the brick wall with no flex or movement at the anchor points. The facility received written quotes for the cardio equipment so they could plan those repairs on their schedule.
Key Takeaway for Equipment Owners
If you are mounting a folding rack like the PRX Profile Pro Ark to any masonry surface, including brick, concrete block, or poured concrete, do not use the same hardware called out for wood stud installation. Each wall material requires a specific anchor type, drill bit, hole depth, and torque value. Using the wrong anchor in brick can look fine on day one and fail under load months later. Have a technician confirm your wall type and anchor selection before the first plate goes on the bar.
Need the Same Fix in Dallas Fort Worth?
2EZ TEK handles commercial equipment installation and cardio floor service across the entire DFW area, with same-week scheduling available for facilities that cannot afford downtime. Call us to get your rack installed right or your cardio equipment back in service.